2HP13/14 & 4HP13 SPLIT SYSTEM HEAT PUMP
INSTALLATION /
/HOMEOWNERS INFORMATION MANUAL
These instructions must be read and understood com pletely before attem pting installation.
TABLE OF CONTENTS
Safety Precautions | 2 | Electrical Connections | 5 |
Unit Location & Installation | 2 | Control Wiring | 5 |
Rooftop Installation & Recommendations | 3 | 6 | |
Indoor Coil Piston Selection | 3 | Adjusting charge | 6 |
Refrigeration Line Sets | 3 | Defrost System | 7 |
Installation of Line Sets | 4 | Single Phase Wiring Diagram | 9 |
Leak Check | 4 | 3 Phase Wiring Diagram | 10 |
Evacuating & Charging | 4 | Homeowner's Information | 11 |
Opening Service Valve | 5 |
|
|
These units are designed for use in residential and light commercial type buildings. Heat Pumps may only be installed with indoor combinations listed in the
Inspect the unit for any damage before installation. If damage is found, notify the transportation company immediately and file a concealed damage claim.
Installation or repairs made by unqualified persons can result in hazards to you and others. Installation MUST conform with local building codes and with the National Electrical Code NFPA 70/ANSI
Im proper installation, adjustm ent, alteration, service or m aintenance will void the warranty. The qualified installer or agency m ust use
NOTE
These instructions are intended as a general guide and do not supersede national, state or local codes in any way.
These instructions must be left with the property owner.
Issue 0847 | Page 1 of 14 |
