Dyna-Glo RMC-KFA210T, RMC-KFA45T G. Photocell, Never Leave The Heater Unattended While Burning

NEVER LEAVE THE HEATER

UNATTENDED WHILE BURNING!

(For RMC-KFA 210T Models Only)

-Remove upper shell (See page 9).

-Remove fan (See page 10).

-Remove ignitor wire from spark plug.

-Remove spark plug from bracket-spark using medium phillips screwdriver.

-Clean and regap spark plug electrodes to 3.5mm gap.(0.138 )

-ReInstall spark plug in bracket-spark.

-Attach ignitor wire to spark plug.

-Reinstall fan and upper shell.

Spark Plug Bracket Burner

Bracket Spark

Gap

Ignitor wire

Figure 16.

G.) PHOTOCELL
CLEAN PHOTOCELL ANNUALLY OR AS NEEDED.
(For RMC-KFA 45T/65T/120T/170T Models Only)
- Remove upper shell (See page 9).
- Remove fan (See page 10).
- Remove photocell from it’s mounting.
Clean photocell lens with cotton swab.	Side cover	Photocell
		lens
TO REPLACE: Remove side cover near
	Photocell	Photocell
on/off switch.
	wires	Install Photocell
- Disconnect wires from circuit board and
		1)Incorrect
remove photocell.
- Install new photocell and attach wires to		2)Correct
circuit board.	circuit board
- Replace fan and upper shell.
		Figure 17.

(For RMC-KFA 210T Model Only)

-Remove upper shell (See page 9).

-Remove fan (See page 10).

-Remove photocell from it’s mounting. Clean photocell lens with cotton swab. TO REPLACE : Remove side cover opposite on/off switch.

-Disconnect wires from circuit board and remove photocell.

-Install new photocell and attach wires to circuit board.

-Replace fan and upper shell.

	Side cover
	Photocell
	lens
	Photocell
	Install Photocell
	1)Incorrect
Photocell	2)Correct
	circuit board
wires

Figure 18.

12