Dyna-Glo RMC-KFA45T, RMC-KFA65T, RMC-KFA120T, RMC-KFA170T, RMC-KFA210T user manual Adaptor Nozzle

NEVER LEAVE THE HEATER

UNATTENDED WHILE BURNING!

I) FUEL VALVE

( For RMC-KFA210T Model only)

-Remove side cover screws using medium phillips screwdriver (See page 13).

-Remove upper shell (See page 9).

-Remove fan (See page 10).

-Pull fuel line (lower and upper) off the fuel valve fittings (See figure 21).

-Disconnet red and orange wires from valve connector (See figure 21).

-Remove 2 screws holding fuel valve and bracket to lower shell Using medium phillips screw driver (See figure 21).

-Remove 2 screws holding fuel valve to Bracket using medium phillps screw driver.(See figure 21).

-Attach new fuel valve to bracket with 2 screws.

-Install new fuel valve and bracket on lower shell with 2 screws.

-Connect red and orange wires (polarity not important) to valve connector (See figue 21).

-Connect upper and lower fuel lines to fuel valve (See figure 21).

-Replace fan, upper shell, side cover.

Electrical Wire	Valve Connector
	Fuel Line
	Hose Upper
Adaptor Nozzle
Fuel Line	Screw
Hose Lower
	Screw
	Bracket
	Valve
	Valve
	Fittings
	Low shell

Figure 21.

14