Dyna-Glo RMC-KFA45T I. Pump Pressure Adjustment, Never Leave The Heater Unattended While Burning

NEVER LEAVE THE HEATER

UNATTENDED WHILE BURNING!

I.) PUMP PRESSURE ADJUSTMENT

-Remove pressure gauge plug from end filter cover.

-Install accessory pressure gauge.

-Start heater (See Operation, page 8)

Allow motor to reach full speed

-Adjust pressure (Using a flat blade screwdriver) Turn relief valve to right to increase pressure. Turn relief valve to left to decrease pressure. Set pump pressure below correct for pressure for each model.

-Stop heater (See Operation, page 9)

-Remove pressure gauge. Replace pressure gauge plug in end filter cover.

MODEL	PUMP PRESSURE
RMC-KFA45T	2.8 psi
RMC-KFA65T	3.5 psi
RMC-KFA120T	4.5 psi
RMC-KFA170T	6.5 psi
RMC-KFA210T	8.5 psi

Pressure Gauge

Plug

Relief Valve

Pressure Gauge

NOTE: USE ONLY ORIGINAL EQUIPMENT REPLACEMENT PARTS.

Use of alternate or third party components will void any warranty and may cause unsafe operation condition.

15