49. MAIN INSERTS
Stereo phone jack for the left and the right channel with breaker function. The
low impedance output is assigned to the tip (send) and the high impedance input
(return) is assigned to the ring of the connector. This jack allows the connection
of external EQs, compressors, limiters, etc. into the master’s signal path. The
insertion point is pre master faders. As well as with the inserts of the monaural
input channels, different DIRECT OUT functions can be accomplished.
Please, also refer to the corresponding section in the description of the MONO
INPUTS.
50. MAIN OUTPUTS
The signals at the MAIN OUTPUTS are post master fader and mainly meant to
feed additional, external power amplifiers. Through these outputs it is also
possible to establish a two way active system set-up. In this case the active
cross-overs – or active active sub woofers – have to be connected to the MAIN
OUTPUTS. If you want to use the internal power amplifier to supply the high
frequency cabinets, the treble signal coming from the cross over has to be fed
back into the PowerMate via the POWER AMP INPUTS.
51. EQ INPUTS / OUTPUTS
The EQ INPUTS are provided through electronically balanced phone jacks with
breaker function. When inserting a phone plug, the signal path is interrupted
between the master and the internal power amplifier. The EQ INPUTS respec-
tively the POWER AMP INPUTS are then the only active inputs for the internal
power amplifier.
The signals at the EQ OUTPUTS are post master fader and post the internal
7-band equalizers. Likewise, the MAIN OUTPUTS can be used for connecting
external devices.
52. POWER AMP INPUTS
The POWER AMP INPUTS are also provided via electronically balanced phone
jacks with breaker function. When inserting a phone plug, the signal path gets
split up between the master and the internal power amplifier. The POWER AMP
INPUTS are then the only active inputs for the internal power amplifier.
NOTE: For detailed information on the functioning and the operation of the
“MASTER PATCHBAY” – MAIN INSERTS, MAIN OUTPUTS, EQ IN/OUTPUTS,
and POWER AMP INPUTS – please refer to the corresponding section; later in
this owner’s manual.
53. FX1/2 FOOTSW.
Phone jack for the connection of a DYNACORD FS11 foot switch, to switch the
effect mode of the internal FX units on or off.
To accomplish this function, the switches FX1 and FX2 have to be engaged.
54. LAMP
This XLR-type socket provides a DC voltage of 12V /2.4 watts and is meant for
the connection of a gooseneck lamp. Please make sure that the used lamp
complies with the here mentioned specifications and pin assignment. Overload
or short circuit can result in damaging this output. To prevent this from
happening, we recommend the use of the
gooseneck lamp (112700), available from the
DYNACORD accessory assortment.
For further information, please consult your
dealer.
MASTER
45