38. MONO OUTPUT
At the monaural output the summed L/R signal of the master is present. It can be used for additional
monitoring, side fill and “next door” applications, or to establish a delay-line.
CAUTION:The outputted signal is not only affected by the setting of the MONO OUT fader but
also by the MASTER faders’ setting.
39. PHONES OUTPUT
Stereo phone jack for the connection of headphones with an impedance of 32 – 600 ohms. The
audio signals of the channels where the PFL button is engaged is outputted via this connector.
40. PHONES LEVEL
This control is used to adjust the headphone’s volume.
CAUTION:
Adjust this control at its minimal setting before connecting the headphones.
41. STANDBY
Pressing the STANDBY button mutes all outputs to which amplifiers could be connected to the
PowerMate. Because the signal flow between the MAIN INSERTS and the MAIN OUTPUTS is
interrupted, the internal power amplifier’s signal is also muted. The STANDBY LED indicates that
the stand-by mode is engaged and the input channel signals are not heard over the speaker
systems. But, the 2Track Return signal is still fed to the power outputs, providing you with a very
comfortable solution to play intermission music during performance breaks.
42. MONO MASTER VOLUME
This fader controls the output level of the MONO OUTPUT. The output level is also influenced by
the setting of the MASTER faders (post fader).
In case a PRE FADER signal split would provide the better solution for your application, this can
be achieved by some minor internal changes.
Please consult your dealer for assistance.
PHONES + MONO OUT + STAND BY43