To p S i d e C o n t r o l I n s t r u c t i o n s
Depending on the Dynasty Spa model you purchased, you'll have different options available to you with Dynasty's digital controls. The operations of your hot tub can be enjoyed at the touch of a button. This section is designed to walk you through the details of the operation of the Dynasty 1000, 2000 & 3000 controls.
D - 1000 System
Initial Start-up
When your spa is first powered up, it will automatically heat and maintain 100
F until you change the setting temperature.
Temperature Adjustment (80
F -104
F)
The current temperature is constantly displayed on the LED. Press either
or 
pad once to display the set temperature. Each time either pad is pressed again, the set temperature will increase or decrease depending upon which pad is pressed. After three seconds, the LED will automatically display the current spa temperature.
Jets
Two Pump Option: Touch the 
pad once to activate the low speed of pump 1. Press the pad again and the high speed of pump 1 and pump 2 will
run. Press the 
pad again to turn off the equipment.
One Pump and Blower Option: Touch the 
pad once to activate the pump's low speed. Press the pad again and the pump's high speed and the blower will run. One more press, and only the pump's high speed will
run. Press the 
pad again to turn off the equipment.
The low speed of pump 1 will run when the heater is turned on or when a filter cycle is activated. If automatically activated, the low speed of pump 1 cannot be disabled from the front panel; however, the high speed of both pumps may be started. The low speed of pump 1 turns off after 2 hours. The high speeds of pump 1, pump 2, or blower (if installed) turn off after
20 minutes.
Light
Press the 
pad to turn the spa light on or off. The light will automat- ically turn off after 1 hour.
12
