24 Changing channel settingsDX-24LD230A12

3Press or to highlight Audio Only, then press

or to select On.
4Press EXIT to close the menu. The picture turns off in
approximately 3 to 5 seconds.
Changing channel settings

Automatically scanning for channels

When you scan for channels, your TV/DVD comb o
searches for channels available in your viewing area and
stores the channel information in the channel list. When
you press CH and CH, your TV/DVD combo tunes to
the next or previous channel in the channel list and skips
any channels that were not stored in the list.
You do not need to scan for channels if you are connected
using a cable or satellite box, which automatically
provides you with a channel list.
To automatically scan for channels:
1Press MENU. The on-screen menu opens with the
Picture menu displayed.
2Press or to highlight Channel. The Channel
menu opens. Press or ENTER/ to access the
menu.
3Press or to highlight Air/Cable, then press or
to select your signal type.
You ca n s ele ct:
•Air—Select this option if you use an antenna.
Your TV/DVD combo scans for analog (VHF and
UHF) and digital channels in your area.
•Cable—Select this option if you have cable TV
and do not have a cable TV box. Your TV/DVD
combo scans for analog and digital channels in
your area.
•Cable/Satellite Box—Select this option if you
use a cable or satellite TV box. Your TV/DVD
combo will not scan for channels because the
cable or satellite TV box provides the channel list.
4Press or to highlight Auto Channel Search,
then press ENTER/.
5A confirmation box opens. Press or to highlight
Yes, then press ENTER/ to start the auto scan.
6A progress box shows the progress of the scan.
Auto Scan may take a while to complete. A progress
report is displayed while your TV/DVD combo is
scanning for available channels. If you select Air,
after the digital channel scan is complete, you can
continue to search for analog channels without
pressing any buttons, or you can press EXIT to exit if
you do not need the analog channel scan.
You can press MENU or EXIT at any time to stop
scanning, but you must run the scan later to
complete the process.
Notes
• Audio only works only when the input source is
TV and your TV/DVD combo is receiving a
broadcast signal.
• To exit audio only mode, press any button.
When you exit audio only mode, the Audio
Only option is automatically reset to Off.
Note
You do not need to scan for channels unless the
available channels changed after you ran the Setup
Wizard. For more information, see “Turning on your
TV/DVD combo for the first time” on page16.
DX-24LD230A12.book Page 24 Tuesday, August 16, 2011 2:58 PM