EAW NT26 Physical Installation, O u n t i n g / R i g g i n g, O d e l s, M p l i f i c a t i o n

NT loudspeakers are designed to meet the requirements and demands of portable applications as well as permanent installations. The integral electronics are based on proven, high efficiency amplifier technology, with field-replaceable amplifier modules. The loudspeakers need to be connected to an ac mains supply and a line level audio signal. The internal DSP is factory preset to provide correct and consistent performance.

4 . 2 . 1 M o d e l s

The 2-way NT loudspeakers are available in both 12-inch and 15-inch LF driver formats. Different beamwidths are offered to meet typical coverage requirements in their intended applications. The trapezoidal design of the enclosures makes them easy to use as a main PA loudspeaker or as a floor wedge for stage monitor applications.

A companion NT subwoofer is engineered to complement the NT full-range loudspeakers. It extends the low frequency response of an NT full-range system and increases the output capabilities at low frequencies. The drivers are installed so one is facing into the enclosure, but connected with opposite polarity so both cones move in the same direction. At high output levels each cone "loads" the other in the opposite direction to smooth out any mechanical asymmetries. The result is significantly reduced distortion.

NT Models:

Full-range	Nominal	LF Driver	H F Driver
	Beamwidths H x V
NT26	60º x 45º	12 in cone, 3 in voice coil	3 in / 1.4 in exit compression driver
NT29	90º x 45º	12 in cone, 3 in voice coil	3 in / 1.4 in exit compression driver
NT56	60º x 45º	15 in cone, 4 in voice coil	3 in / 1.4 in exit compression driver
NT59	90º x 45º	15 in cone, 4 in voice coil	3 in / 1.4 in exit compression driver
Subwoofer
NTS22	N/A	2x 12 in cone, 4 in voice coil	N/A

4 . 2 . 2 A m p l i f i c a t i o n

As is true of all professional loudspeaker systems, the performance of the NT Series loudspeakers depends on amplifiers delivering an adequate supply of clean power. To maximize performance, the full-range loudspeakers are bi-amplified, meaning the LF and HF drivers each have their own signal processing and built-in, high-efficiency amplifier. The subwoofer is dual-amplified, meaning each driver has its own, built-in, high efficiency amplifier.

Loudspeaker	LF Amplifier	HF Amplifier
Full-range	1000 W	500 W
Subwoofer	2x 1000 W	N/A

Section 5 Physical Installation

5 . 1 M o u n t i n g / R i g g i n g

Read and heed all warnings and safety instructions in the supplied "EAW Loudspeaker Manual" before using this product. Failure to follow this precaution may result in equipment damage, personal injury, or death.

NOTE: The CSA (Canadian Standards Association) approval rating does not include any evaluation of mounting / rigging capabilities.

8