EAW NT56, NTS22, NT26, NT29 Unpacking, Quick Start, N t e n t s, C M a i n s C o n n e c t i o n

Section 2		Unpacking
2 . 1	C o n t e n t s
	Qty	Item
	1	NT Series Product
	1	Power Cable (dependent on product's ac mains rating)
		115 V - Neutrik PowerCon to Nema 15R plug
		230 V - Neutrik PowerCon to male Schuko plug
	1	Owner's Manual (this document)
	1	EAW Loudspeaker Owner's Manual
	1	Warranty Card

Section 3 Quick Start

If you are in a hurry or are knowledgeable about using powered loudspeakers, these Quick Start instructions provide the details particular to the NT Series loudspeakers. For the instructions in this section, refer to the accompanying Figures.

3 . 1 I n i t i a l C o n t r o l S e t t i n g s

Use these nominal settings for the rear panel switches.

Full-Range with no subwoofer

HPF55 Hz

ModeNormal

Full-Range with subwoofer

HPF110 Hz

ModeNormal

Subwoofer

Gain0 dB

Polarity Normal

WARNING: Before connecting an NT loudspeaker to the ac mains supply, completely turn down the input signal to the loudspeaker using the signal source's output level (master volume control or other output level control). If not, there could be excessive and possibly damaging sound levels from the loudspeaker when energized.

3 . 2 A u d i o C o n n e c t i o n

Connect the output from your line-level signal source to the XLR-3F Input connector on the rear panel. This is an electronically balanced input.

3 . 3 A C M a i n s C o n n e c t i o n

Connect the supplied ac mains cord to the Neutrik PowerCon socket on the rear of the loudspeaker. Connect the other end to an ac mains supply receptacle, nominal 115 V 60 Hz or 230 V 50 Hz as labeled on the loudspeaker. If necessary, have a qualified electrician change the cable plug as required for compatibility with the local ac mains receptacle.

2