Echo CS-360T, CS-330T instruction manual Chain and Guide Bar Combinations, Distancia, Eslabones

High Altitude Adjustment

1.Start engine and run for several minutes to reach operating temperature.

2.Stop engine.

3.Start engine and turn the HI speed needle (A) lean (CW) until the engine runs between 13,500 and 14,500 RPM. Then turn the LO speed needle lean (B) (CW) until the engine does not hesitate when accelerated.

DO NOT REMOVE LIMITER CAPS!

4.Idle Speed Adjustment.

• Turn “idle” speed adjustment screw (C) CW until the saw chain begins to move, then turn the screw CCW until saw chain stops moving. Turn screw CCW an additional 1/4 turn.

5.Accelerate to full throttle for 2-3 seconds to clear excess fuel from engine then return to idle. Accelerate to full throttle to check for smooth transition from idle to full throttle. If engine stops or stalls after full warm up return the unit to your autho- rized ECHO dealer for adjustment.

C

A B

		Chain and Guide Bar Combinations
	The following combinations may be used on CS-330T and CS-360T.
			GUÍA DE LA
	LARGO		BARRA	CADENA DE SIERRA CONTRAGOLPE BAJO
			CONTRAGOLPE
MODELO	DE
			BAJO
	BARRA
			N/P BARRA	N/P CADENA	DISTANCIA	TYPO	ESLABONES	GA
CS-330T	12 pulg		12A0ED3745	91VG-45	45
	14 pulg		14A0ED3752	91VG-52	52	91VG	3/8"	0.050
CS-360T
	16 pulg		16A0ED3757	91VG-57	57

*Reduced nose radius symmetrical bars (OREGON name — Double Guard)

WARNING

Use of replacement saw chain and/or guide bar other than that specified, or operation without the “tip guard” in place, may cause severe kickback resulting in serious injury.

Only use saw chain designated as, “LOW-KICKBACK,” that meets the ANSI B175.1-2000 Standard when tested on the representative sample of chain saws below 3.8 C.I.P. specified, and the Echo guide bar specified.

IMPORTANT

Chain and guide bar gauge size must be identical. Use Bar/Chain combinations shown in table above.

IMPORTANT

If your kick guard is damaged or lost, contact your Echo dealer for a replacement. For the name of the Echo dealer nearest you, Call: 1-800-432-ECHO (3246) or on the web at www.echo-usa.com.

Refer to your Chain Saw Safety Manual for kick guard application information.

23