18

AIR FILTER

Level 1.

Tools required: 25-50 mm (1-2 in.) medium bristle paint brush.

Parts required: 90030 REPOWERTM Air and Fuel Filter Kit

NOTE

Clean daily.

1.Close choke (Cold Start Position). This prevents dirt from entering the carburetor throat when the air filter is removed. Brush accumulated dirt from the air cleaner area.

2.Remove the air cleaner cover. Clean and inspect the element for damage. If element is fuel soaked and very dirty, replace.

3.If element can be cleaned and reused, be certain it: •still fits the cavity in the air cleaner cover.

•is installed with the original side out.

FUEL FILTER

Level 1.

Tools required: Fuel line hook. 203-254 mm (8-10 in.) length of wire with one end bent into a hook. Clean rag, funnel, and an approved fuel container.

Parts required: 90030 REPOWERTM Air and Filter Kit

WARNING DANGER

Fuel is VERY flammable. Use extreme care when mixing, storing or handling.

1.Use a clean rag to remove loose dirt from around fuel cap and empty fuel tank.

2.Use the “fuel line hook” to pull the fuel line and filter from the tank.

3.Remove the filter from the line and install the new filter.