
Handle assembling bolt (8 mm) |
| ||
Handle assembling |
|
| |
bracket (upper) | Washer |
| |
|
| Wire fixing clip | |
Handle assembling |
| Shaft tube | |
To engine | Throttle wire | ||
bracket (lower) | |||
|
|
ASSEMBLING
Install handle assembling bracket (upper) in handle assembling bracket (lower) and fix handle by tightening handle assembling bolt (8 mm) lightly.
Adjust inclination of handle to adequate position (easy to operate) and tighten firmly handle assembling bolt (8 mm).
To eliminate loosening of throttle wire fix it to shaft tube (2 places) and to right hand
1 - 2 mm | Wire end |
Nuts
Carburettor
CAUTION
After assembly, adjust the play of wire end on carburettor side to 1 mm - 2 mm.
Bracket
Convex of fitting plate
Notch of fitting plate
Screw M5⋅ 18
Shield
Fitting plate | Bolt M5×25 | Bracket |
INSTALLATION OF BRACKET
Fit bracket to mounting portion of angle transmission and fix the bracket by holding fitting plate pressed from beneath and tightening 4 bolts (M5⋅ 25) lightly.
Get notches and convexes of fitting plate to face corresponding convexes and concaves of bracket, and fix bracket tightening 4 bolts (M5⋅ 25) securely.
There are two types of shields: namely one used exclusively for Nylon line and another one used exclusively for steel blade. When Nylon line is used, use the shield for Nylon line. When steel blade is used, use the shield for steel blade.
METHOD TO CHANGE SHIELD (FOR STEEL BLADE)
Remove screw (M5⋅ 18) on the right side of the shield and slide the shield to the left and remove it. Put shield of another type into groove and slide it to the right until it stops and be sure to fasten with the removed screw (M5⋅ 18). When using Nylon line, use the shield for Nylon line (see page 15). Fit cut off knife to the shield for Nylon line using screw (5⋅ 12).
13 |