F-4/10

NYLON LINE CUTTING ATTACHMENT

Type: F-4/10

Thread:

Left-hand thread M10 × 1.25 pitch

CAUTION

Use only flexible, non-metallic line recommended by KIORITZ CORPORATION.

Tap knob

Hit knob against the ground surface lightly

Nylon line comes out

ADJUSTING NYLON LINE

•Make sure there is no bystander within 15 m radius and pay enough attention to objects in the surroundings before starting operation.

•Do not rotate the cutting head at more than 10,000 r/mim.

•Do not hit the cutting head against hard foreign matters such as rocks, concrete, tree stub and bottle etc.

•When releasing Nylon line from spool hit tap knob of spool against the ground surface lightly at rotation speed lower than 4,500 r/min.

•Cut off knife on the guard adjusts cutting swath to 40 cm automatically by cutting nylon lines evenly when attachment starts rotating.

•When operating with less than maximum cutting swath (40 cm), cut two nylon lines in equal lengths.

REPLACING NYLON LINE

WARNING DANGER

SHUT DOWN TRIMMER ENGINE WITHOUT FAIL AND MAKE SURE CUTTING HEAD HAS STOPPED ROTATING BEFORE STARTING REPLACEMENT PROCEDURE.

HousingSpool

(2)

(3)

(1)

Tap knob of spool

Cover

(1)Press “retaining pawls” (at two places) inward and remove cover.

It is easier to remove one after another.

(2)Remove spool.

(3)When Nylon line on the spool is almost exhausted, remove remaining line from spool and wind “new line” according to the procedures (4) and beyond.

When the line on the spool is “melted and stuck” remove the entire line while peeling off the “melted and stuck” portion and wind the “removed line” anew according to procedures (4) and beyond.

15SRM-2305