Silencer cover
Two bolts
Silencer
CLEANING SILENCER
•Clean deposits from silencer and tighten two bolts.
CHECK FUEL SYSTEM
•Check before every use.
•After refuelling, make sure fuel does not leak or exude from around fuel pipe, fuel grommet or fuel tank cap.
•In case of fuel leakage or exudation there is a danger of fire. Stop using the machine immediately and request your dealer to inspect or replace.
Angle transmission
Plug (Bolt)
0.6 to 0.7 mm
CHECK SPARK PLUG
•Check plug gap. Correct gap is 0.6 to 0.7 mm.
•Inspect electrode for wear.
•Inspect insulator for oil or other deposits.
•Replace plug if needed and tighten to 15 - 17 N·m (150 to 170 kgf·cm).
ANGLE TRANSMISSION
•Remove plug from angle transmission.
•Add grease, if necessary, using low pressure pump.
•Reinstall plug.
NOTE
Use good quality lithium multi grease. DO NOT overfill housing.
30°
CHECKING THE BLADE
•Use only the blade designated for this model by the manufacturer.
•When a crack is noticed on the blade, do not use it but replace with a new one.
•Ensure that the blade is correctly fitted in accordance with the instructions.
•When the cutting blade becomes dull due to wear reverse it for further use.
•When chip or bend occurs on the blade, vibration will increase.
Replace with a new one.
•When filing the blade file 3 cutting edges evenly using a flat file as shown in the illustration. Otherwise, the balance will be lost and vibration will increase.
20 |