Echo SRM-280, SRM-280S, SRM-280T manual

U-Handle Kit Installation

Instructions P/N 99944200689

For Models: SRM-280/280S/280T S/N ALL

WARNING

You must install a Barrier Bar or U-Handle Kit and all Blade Conversion parts shown in the following instructions before operating this unit with blades, otherwise serious injury may result.

IMPORTANT

If non-standard monofilament heads, METAL/PLASTIC blades or cultivators etc., are used, THE CARBURETOR MUST BE RESET or serious engine damage can occur. See "Carburetor Adjustment" in the unit Operator's Manual.

SRM/PAS/SB BLADE SET-UP GUIDE*

TO USE
					Metal 22T Clearing Saw Bla
THESE BLADES
		Loop Handle, w/or	Loop Handle	Loop Handle
	Handle		w/Barrier Bar,	w/Barrier Bar,	U-Handle
		w/o Barrier Bar
You			or U-Handle	or U-Handle
must	Debris Shield	Metal Shield	Metal Shield	Metal Shield	Metal Shield
install
	Harness	Shoulder Harness	Shoulder Harness	Shoulder Harness	Shoulder Harness****
these
		Upper Plate &	Upper Plate	Upper/Lower	Upper/Lower
parts!	Blade
		Flat Washer	& Glide Cup	Blade Plates**	Blade Plates**
	Mounting
		Hex Nut	Hex Nut	Hex Nut	Hex Nut
	Hardware
		New Cotter Pin***	New Cotter Pin***	New Cotter Pin***	New Cotter Pin***

*WARNING! DO NOT INSTALL BLADES ON GT (CURVED SHAFT) MODEL TRIMMERS

**Arbor diameter of Upper Blade Plate must match arbor diameter of metal blades.

***New cotter pin required each time blade is installed.

****Brushcutters over 16.5 lbs (7.5 kg) dry weight (weight w/o fuel) require a double shoulder harness

Contents

1 U-handle assembly

1Lower u-handle bracket (2 halves)

1Harness clamp w/ring

15 x 12 mm bolt

18 x 55 mm bolt

1Circular washer

1Square nut

2Throttle cable clips

35 x 30 mm bolts w/washers

1Shoulder harness

1Hip pad

X7502234701	X750011731
	10/09