3 |
9.Insert square nut (I) in lower handle bracket (J) and place bracket on drive shaft 400mm (15 3/4 in.) from engine end of drive shaft.
10.Secure with lower handle bracket clamp (K) and three (3) 5mm x 30mm hex socket bolts.
11.Position harness clamp (L) 220 mm
12.Carefully fit drive shaft assembly to engine making sure inner drive shaft engages into clutch socket.
13.Turn drive shaft housing until locating hole lines up with location hole in clamp and install center drive shaft location bolt (F).
NOTEGear Housing must be aligned properly with engine. Aligning center locating hole in driveshaft housing with center drive shaft bolt
(F)provides correct alignment.
14.Tighten two (2) drive shaft clamp bolts (E) securely.
15.Install upper
16.Route throttle linkage and ignition lead assembly behind
I
J
K
400mm
L
ENGINE
END
K | J |
| 220 mm |
| |||
| |||
|
|
|
E
F
E
M