
2 | |
| Installation |
Tools Required: 8mm x 10mm Open End Wrench, 19 mm wrench
4 mm hex wrench, screwdriver
1.Close choke and remove air filter and cover.
2.Disconnect ignition stop leads (A) and (B).
A
B
A
B
3.Loosen nuts (C) and remove throttle linkage from carburetor bracket.
4.Remove inner throttle cable from carburetor swivel (D).
D
C
5.Loosen the two (2) drive shaft clamp bolts (E) at engine drive shaft clamp, and remove center drive shaft location bolt (F).
E E
6.Pull drive shaft assembly from clutch case.
F
7.Loosen two (2) rear handle screws (G) and pull rear handle from
the drive shaft assembly. | H |
8.Loosen two (2) screws (H) and remove front handle.
G