4

U-Handle Kit Installation Instructions

17.Place inner throttle cable in large hole of carburetor swivel (D).

18.Loosen nuts (C) and place threaded end of throttle linkage in bracket slot. Finger tighten nuts (C).

19.Check throttle for freedom of movement and that wide open throttle / low idle extremes are adjusted properly. If adjustment cannot be achieved with adjusting nuts (C), consult with your

Echo Dealer for correct adjustment procedure. Tighten nuts (C).

20.Connect 2 ignition stop leads (A,B) from throttle cable tubing to 2 ignition leads (A,B) on engine.

21.Gather ignition wires and position behind air filter case.

22.Install air filter and cover

D

C

AA

BB

Install Hip Pad (Optional)

1.Attach hip pad to harness as shown.