B16132-R0-261ENRC-UC-ENG 7/11/07 11:52 AM Page 18
WIRING CONDUIT
INSERT SCREWDRIVER TO LIFT
AND REMOVE WIRE COVER
KNOCK OUT
FOR SURFACE WIRING
CONDUIT
| IC |
L | N |
TERMINAL SCREWS
L - LIVE
N - NEUTRAL
IC - INTERCONNECT
| IC |
L | N |
|
| WIRING |
|
SEALING GASKET | KNOCK OUT FOR | CONDUIT |
|
(MUST BE IN PLACE) | MAINS WIRING |
| |
SURFACE WIRING |
| ||
|
| ||
| CONDUIT |
|
|
|
| RECESSED WIRING AREA | EARTH (IF PRESENT) |
Figure 5 - Surface Wiring | Figure 6 - Recessed Wiring | ||
11.Connect the mains power to the alarm circuit. Check the green light is on.
The CO Alarm is now fully operational and will provide protection against a build up of Carbon Monoxide gas 70 seconds after it is connected to the mains supply.
12.The unit may be tamperproofed further by removing the knockout in the sidewall of the mounting plate (as shown in Figure 4) and inserting the self tapping screw (3mm diameter, 12mm long) after the unit is on the mounting plate.
18
