B16132-R0-261ENRC-UC-ENG 7/11/07 11:52 AM Page 20
A maximum of 250 metres (820 ft) of wire can be used (maximum resistance between detectors 50 Ohms). Connect as shown in Figure 7.
Alarms should be interconnected only within the confines of a single family living unit. If they are connected between different units there may be excessive nuisance alarms. Everybody may not be aware that they are being tested etc.
If interconnected CO and Smoke/Heat Alarms are all sounding, the LOCATE switch on the Ei1529RC Remote Control should be pressed. This will just leave the alarm that triggered the system sounding.
This is very important to determine because the actions to take in each situation are very different.
In the case of CO the premises should be fully ventilated by opening doors and windows. The user should call the gas supplier etc.
In the case of fire, doors and windows should be closed to slow the spread of fire. The user should call the fire brigade etc.
5.TESTING
1.Regularly check that the green mains power light is on. The unit cannot detect CO if the mains power is off and the rechargeable battery
2.Test the unit weekly by pressing the Test/Hush button. Hold the Test button (for up to 10 seconds) until the horn sounds for over 5 seconds. This will help to familiarise you and your family with the distinctive
3.If the Alarm gives a short beep and the amber fault light flashes every 40 seconds it means the self-
20
