APPENDIX
When the life of the Lamp of this projector draws to an end, the LAMP REPLACEMENT indicator lights yellow. When the image becomes dark or the color of the image becomes unnatural, replacement of the Lamp is required.
CAUTION
• For continued safety, replace with a lamp assembly of the same type.
•AIlow the projector to cool for at least 45 minutes before you open the lamp cover. The inside of the projector can become very hot.
•Do not drop the lamp assembly or touch the glass bulb The glass can shatter and may cause injury.
Follow these steps to replace the lamp assembly.
1Turn off the projector and disconnect the AC plug. Allow the projector to cool for at least 45 minutes.
2Remove the screw with a screwdriver and remove the Lamp Cover.
3Remove the two screws with a screwdriver and pull out the Lamp Assembly by grasping the handle.
4Replace the Lamp Assembly with a new one and tighten the two screws. Make sure that the Lamp Assembly is set properly. Replace the Lamp Cover and tighten the screw.
5Connect the AC Power Cord to the projector and turn the projector on.
6Reset the Lamp Replacement Monitor Timer (refer to the section “Lamp Replacement Monitor Timer” below).
NOTE: Do not reset the LAMP REPLACEMENT MONITOR
TIMER when the lamp is not replaced.
ORDER REPLACEMENT LAMP
Replacement Lamp can be ordered through your dealer. When ordering the Lamp, give the following information to the dealer.
•Model No. of your projector :
•Replacement Lamp Type No.:
(Service Parts No, 610 285 2912)
LAMP REPLACEMENT MONITOR TIMER
Be sure to reset the Lamp Replacement Monitor Timer when the Lamp Assembly is replaced. When the Lamp Replacement Monitor Timer is reset, the LAMP REPLACEMENT indicator stops lighting.
1Turn the projector on, and press the MENU button and the
2Press the POINT DOWN button and a
3Select (Yes) to reset the Timer.
Do not reset the Lamp Replacement Monitor Timer, except after the lamp is replaced.
36
