Eiki LC-W4 instruction manual Basic Operation, Turning on / OFF Projector, Turning on Projector

BASIC OPERATION

TURNING ON / OFF PROJECTOR

TURNING ON PROJECTOR

1	Complete peripheral connections (with Computer, VCR, etc.)
	before turning on projector. (Refer to "CONNECTING TO
	PROJECTOR" on Pages 12~15 for connecting that equipment.)
2	Connect a projector's AC Power Cord into a wall outlet and turn
	MAIN ON / OFF SWITCH to ON. LAMP indicator lights RED,
	and READY indicator lights GREEN.
3	Press POWER ON-OFF button on Top Control or on Remote
	Control Unit to ON. LAMP indicator dims, and Cooling Fans start

to operate. Preparation Display appears on a screen and count- down starts. Signal from source appears after 30 seconds. Current Input position and Lamp status are also displayed on screen for 5 seconds. (Refer to "LAMP MANAGEMENT" on page 45.)

LAMP STATUS

INPUT 1

1 2

30

Preparation Display disappears after 30 seconds.

TURNING OFF PROJECTOR

1

2

3

Press POWER ON-OFF button on Top Control or on Remote Control Unit, and a message "Power off?" appears on a screen.

Press POWER ON-OFF button again to turn off projector. LAMP indicator lights bright and READY indicator turns off. After approximate 90 seconds, READY indicator will light green again and projector may be turned on by pressing POWER ON-OFF button.

Cooling fans will operate for approximate 2 minutes after projec- tor is turned off. To power down completely, turn MAIN ON/OFF SWITCH to OFF and disconnect AC Power Cord.

TO MAINTAIN LIFE OF LAMP, ONCE YOU TURN PROJECTOR ON, WAIT AT LEAST 5 MINUTES BEFORE TURNING IT OFF.

Power off?

Message disappears after 4 seconds.

When Power Management function mode is Ready or Shut down, projector detects signal interruption and turns off Projection Lamp automatically. Refer to “Power Management” on pages 39 and 40.

When WARNING TEMP. indicator flashes red, projector is automatically turned off. Wait at least 5 minutes before turning on projector again.

When both WARNING TEMP. and READY indicators to flash, follow procedures below:

1.Turn MAIN ON / OFF SWITCH to OFF.

2.Turn a projector on again.

When WARNING TEMP. indicator continues to flash, follow procedures below:

1.Turn MAIN ON / OFF SWITCH to OFF and disconnect AC Power Cord from an AC outlet.

2.Check Air Filters for dust accumulation.

3.Clean Air Filters. (See "AIR FILTER CARE AND CLEANING" section on page 44.)

4.Turn a projector on again.

If WARNING TEMP. indicator should still continue to flash, contact sales dealer where you purchased this projector or service center.

21