Eiki LC-XB26 Remote Control Code, Remote Control Battery Installation, Part Names and Functions

Part Names and Functions

Remote Control Code

This projector has eight different remote control codes (Code 1-Code 8). Switching remote control codes prevents remote control interference when operating several projectors or video equipment at the same time. Change the remote control code for the projector first before changing that for the remote control. See “Remote control” in Setting on page 46.

1	With holding down the MENU button, press the IMAGE
	button. The code switches sequentially for one pressing the
	IMAGE button. (See the list below.)
2	To initialize the	remote control code, slide the
	RESET/ON/ALL-OFF switch to RESET, and then to ON. The
	initial code is Code 1. (p11)
	Remote Control Code	Number of Times of
		Pressing IMAGE Button
	Code 1	1
	Code 2	2
	Code 3	3
	Code 4	4
	Code 5	5
	Code 6	6
	Code 7	7
	Code 8	8

IMAGE button

While pressing the MENU button, press the IMAGE button number of times corresponding to the remote control code.

MENU button

Remote Control Battery Installation

1	Remove the battery
	compartment lid.

Press the lid downward and slide it.

2	Slide the batteries into	3	Replace the compartment
	the compartment.		lid.

Two AA size batteries For correct polarity (+ and

–), be sure battery terminals are in contact with pins in compartment.

To insure safe operation, please observe the following precautions :

●Use (2) AA, UM3 or LR6 type alkaline batteries.

●Replace two batteries at the same time.

●Do not use a new battery with a used battery.

●Avoid contact with water or liquid.

●Do not expose the remote control to moisture, or heat.

●Do not drop the remote control.

●If a battery has leaked on remote control, carefully wipe case clean and install new batteries.

●Risk of explosion if battery is replaced by an incorrect type.

●Dispose of used batteries according to the instructions.

14