22 Chapter2AdjustingScreens

2.

Prepare to use analog screen adjustment patterns.

Load the “EIZO LCD Utility Disk” to your P C, and then open the “Screen adjustment patte rn les”.
Note
• For detai ls and instructions on op ening the “Screen adjustme nt pattern les”, refer to the Readme.txt  le.

3.

Perform the auto adjustment again with the analog screen adjustment pattern

displayed.

● To adjust ickering, screen position, and screen size automatically
Procedure
1. Display Patte rn 1 in full screen on the monitor using t he “Screen adjustment pattern les”.
2. Choose “ Screen” in the Setting menu, and press .
3. Choose “Analog Adjustment” i n the “Screen” menu, and press .
4. Choose “Auto Screen Adjust” in the “Analog Adjustment” me nu, and press .
5. Select “Yes” with or , and press .
Flickering, screen position, a nd screen size are correcte d by the auto-adjustment fu nction.
Ifthescreenisnotdisplayedcorrectlyevenaf terperformingtheautoadjustment,per formadjustments
accordingtothefollowingprocedure.Ifthescre enisdisplayedcorrectly,goto“5.Adjustingcolorgradation.”
(page24).

4.

Choose “Screen” from the Setting menu to perform advanced adjustments.

Adjust the clock, phase and position, in this order.
● To eliminate vertical bars
Procedure
1. Choose “Analog Adjustment” i n the “Screen” menu, and press .
2. Choose “Clock ” in the “Analog Adjustment” menu, and press .
The “Clock” menu appears.
3. Adjust the clock with or to eli minate vertical bars.
Press or slowly so as not to miss the adjustme nt point.
4. Pre ss to exit.
When blurring, icker ing or bars appear on the scree n after adjustment, proceed t o “To remove ickering or blurring ”.