ELAN Home Systems V883 manual DIP Switch Settings Baud Rate, 19.2K Baud

E L A N H O M E S Y S T E M S V883 INSTALLATION MANUAL

DIP Switch Settings - BAUD RATE

Set the BAUD RATE DIP switch to the 9600 position (Up) when utilizing RS-232 con- trollers that require this baud rate. Use the 19.2k (Down) position for ELAN RS-232 applications and third party controllers that operate at 19.2k.

UNIT ID	RATE
UNIT 1	9.6KBAUD
UNIT 3
UNIT 2
	/
UNIT 4	19.2K

1 2 3

9.6K BAUD

UNIT ID	RATE
UNIT 1	9.6KBAUD
UNIT 3
UNIT 2
	/
UNIT 4	19.2K

1 2 3

19.2K BAUD

(Factory Default)

75 Ohm Termination DIP Switch Settings

There are eight 75 Ohm Termination DIP Switches used to optimize video signals when sharing sources with other devices or using multiple V883s. For each input that is shared using a ‘Y’ cable, place the corresponding DIP switch in the OFF/ DOWN position. When not sharing a source, the DIP switch should remain in the factory default ON/UP position.

Not Shared	Shared
Source	Source

75 OHM

INPUT

TERM

ON/UP OFF/DOWN

(Factory Default)

© ELAN Home Systems 2006 • All rights reserved. Page 11