E L A N H O M E S Y S T E M S | V883 INSTALLATION MANUAL |
Video Switching
SYMPTOM | CAUSE | SOLUTION |
Video does not appear on desired | 1. V883 output cables incorrectly | Verify/correct video output wiring. |
TV/monitor. Front of V883 displays | routed. TV/monitor connected |
|
correct source/zone. | to incorrect output. |
|
| 2. TV/monitor has incorrect input | Select correct video input on |
| selected. | TV/monitor. |
|
|
|
| 3. Video wiring bad/damaged. | Verify/correct video wiring. |
|
|
|
| 4. Video source not sending video | Verify/correct video source |
| (not connected, playing, or | problem. |
| turned on). |
|
|
|
|
Incorrect source displays on | V883 input cables incorrectly | Verify/correct video input wiring. |
TV/monitor. Front of V883 displays | routed. Source connected to |
|
correct source/zone. | incorrect V883 input. |
|
|
|
|
Incorrect source displays on | Incorrect programming. | Verify/correct IR programming. |
TV/monitor. Front of V883 displays |
|
|
incorrect source/zone. |
|
|
|
|
|
Component video sources display | 1. Composite video source not | Ensure same type (Y, PB, PR) input |
correctly, composite source does | connected to same type (Y, PB, PR) | & output used for all composite |
not display at all. | input as TV/monitor. | video sources and TVs/monitors. |
|
|
|
| 2. TV/monitor has incorrect input | Select correct composite video |
| selected. | input on TV/monitor. |
|
|
|
Video Quality
SYMPTOM | CAUSE | SOLUTION |
| |
Video image is not optimal | 1. | Do not run video wiring near AC |
| |
(i.e., fuzzy, blurry, smeared, | up noise from | lines. If necessary, cross AC lines |
| |
ghosted, or dull). | or other source of interference. | at 90 degrees. |
| |
| 2. | Make gradual bends in coax when |
| |
| bends or using poor quality | running wire. Use |
| |
| cable. |
| ||
|
|
|
|
|
| 3. Video wiring bad/damaged. | Verify/correct video wiring. |
| |
|
|
|
|
|
| 4. Incorrect 75 Ohm DIP switch | Verify/correct 75 Ohm DIP switch |
| |
| setting when sharing sources or | settings. |
| |
| utilizing multiple chassis. |
|
|
|
|
|
|
|
|
Video image colors incorrect, | 1. Component video cables con- | Verify/correct component video |
| |
scrambled, jagged lines, etc. | nected to wrong type (Y, PB, PR) | input/output wiring. |
| |
| of inputs/outputs at V883 or |
|
|
|
| TV/monitor. |
|
|
|
|
|
|
|
|
| 2. One or more component video | Verify/correct component video |
| |
| connections (Y, PB, PR) not | input/output wiring. |
| |
| made. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
© ELAN Home Systems 2006 • All rights reserved. | Page 25 |
