ELAN Home Systems V883

ELAN HOME SYSTEMS

V883 INSTALLATION MANUAL

2. Control Connections & Settings

Control Connections - IR

There are two IR pathways into the V883 - the 3.5mm IR IN port on the rear and the

IR Receiver on the front. The IR OUT port passes out any IR signal that is sent to the

V883’s rear IR IN port or the front IR Receiver.

IR IN Port

Most ELAN multi-room applications will utilize the rear IR IN port for IR control. Use

a 3.5mm mono interconnect cable to connect between an IR OUT port (typically an

‘ALL’ port) of an ELAN multi-room controller and the IR IN port of the V883. In this

conﬁ guration, any IR signal sent from any zone of the multi-room system will be sent

to the V883.

IR IN

IR OUT

IR ALL

OUT

3.5mm Mono

Interconnect

Cable

V883

ELAN

Multi-Room

Controller

Hand-Held

IR Remote

Mini-Emitter

IR Receiver IR Receiver

+12V

GND

ST OUT

IR IN

RCVR

STATUS IN

5~24V DC

12V DC

REGULATED

HP ON

NET ON

LP ON

NET OFF

IRD4

Amplified Connection Block

IR OUT LP/HP IR OUT

IRD4 Amplified

IR Connection Block

IR Receiver

Use the built-in IR Receiver located on the front of the unit when utilizing hand-held

IR remotes, IR distribution systems, or when it is otherwise not possible to connect

to the IR IN port. IR commands can be sent from a distance using a hand-held IR

remote or IR “blaster”. Use a standard IR mini-emitter placed directly over the

V883’s IR receiver when used in conjunction with most IR distribution networks.