V883 INSTALLATION MANUALE L A N H O M E S Y S T E M S
RS-232 Control
SYMPTOM | CAUSE | SOLUTION | ||
No source or zone selected | 1. | Verify/correct programming. | ||
from |
| programmed. |
| |
|
|
| ||
| 2. | Verify | ||
|
|
| integrity an | |
|
|
|
| |
| 3. | UNIT ID DIP switches incorrect. | Verify/correct DIP switches. | |
|
|
|
| |
| 4. | BAUD RATE switches incorrect. | Verify/correct DIP switches. | |
|
|
| ||
Incorrect source and/or zone | The V883 | Verify/correct programming. | ||
selected. | were incorrectly programmed. |
| ||
|
|
| ||
Acknowledgement | 1. The command was formatted | Verify/correct programming. | ||
&V883,ACK,xxx<CR> is not |
| incorrectly. |
| |
received within 200ms |
|
|
| |
2. | An error has occurred in the | Turn unit OFF, then back ON. | ||
| ||||
|
| V883. |
| |
|
|
| ||
| 3. Serial cable not connected | Connect or replace serial cable. | ||
|
| or defective. |
| |
|
|
|
| |
| 4. | V883 does not have power. | Connect power, check breakers. | |
|
|
|
| |
VIA!NET Control
SYMPTOM | CAUSE | SOLUTION | |
No source or zone selected | 1. VIA!NET controller not | Program VIA!NET controller. | |
from VIA!NET controller (VIA! | programmed. |
| |
Touch Panel, etc.). |
|
| |
2. VIA!NET signal path wiring bad. | Verify VIA!NET wiring. | ||
| |||
|
|
| |
| 3. UNIT ID DIP switches incorrect. | Verify/correct DIP switches. | |
|
|
| |
Incorrect source and/or zone | Incorrect V883 VIA!NET com- | Verify/correct programming. | |
selected. | mands programmed. |
| |
|
|
|
Page 24 | © ELAN Home Systems 2006 • All rights reserved. |
