04 | Trouble Shooting Guide |
| |
|
|
|
|
| Problem | Possible Causes | Solutions |
|
|
|
|
| No audio and no display on | Receiver is off | Make sure that the power supply is properly |
| the receiver | connected and the on/off button is in the on position | |
|
| ||
|
| Transmitter is off | Turn on transmitter power switch |
| No audio and no RF | Transmitter is on a different channel or is | Check band information on serial number label and |
| signal indicator on the | a different band | match to receiver, reset channel (see section 2.1) |
| receiver display |
|
|
| No (or dead) battery in transmitter | Insert fresh batteries in transmitter | |
|
| ||
|
| Faulty battery contacts | Clean and or bend contacts to improve connection |
|
|
| Check the TA4F connector on the bodypack or the |
| No Audio with good RF | Microphone not connected | detachable microphone element connection on the |
| signal indicator |
| handheld. If possible, try another microphone. |
|
| Transmitter Mute On | Press and hold On/Off button to stop Mute. |
| No (or low) Audio with good | Receiver audio output cable is damaged | Connect, repair or replace cable |
| or disconnected |
| |
| RF signal and Audio indicators | Gain not sufficient on mixer/preamp/amp | Increase gain on mixer or |
| on receiver display | input or it is muted |
|
|
| Receiver output too low | Increase the audio output setting. |
|
| Receiver output too high | Decrease the receiver output setting |
| Distorted audio signal | Loud instrument or audio source | Change the bodypack gain switch to INS |
|
| Battery level low in transmitter | Insert fresh batteries in transmitter |
|
| Another R300 system in the installation | Make certain all units are on different channels. If |
| Interference | is on the same channel or signals | more channels are needed call EV at |
|
| are mixing | for coordination help |
22