![2.1 Receiver Setup & Operation](/images/new-backgrounds/14136/1413615x1.webp)
02 | Detailed component descriptions |
2.1 Receiver Setup & Operation
1. Place the receiver and antennas where there is a clear line of sight to the area where the transmitter | ||||
will be used. Rotate the antennas to separate them by 90 degrees. | ||||
2. Install the appropriate power connection blades into the power supply and connect the | ||||
power supply cord to the receiver. Plug the power supply into an AC outlet. Push the power | ||||
button to turn the receiver on and confirm that it is on by checking the main display screen. | ||||
|
|
| ||
| MIN MAX | LEVEL |
| |
ANTENNA B | VOLUME | BALANCED OUT UNBALANCED OUT | 12V .500mA | ANTENNA A |
3. Manual Channel Change |
| |||
| a. The | and | buttons allow you to scroll through the Channels. When the Channel | |
| you desire is displayed, stop scrolling. | |||
| b. After 2 seconds the displayed channel number will start to flash. | |||
| c. The number will stop flashing and the new channel is installed. | |||
| d. Turn on the transmitter and hold the EZsync port facing the receiver EZSync port, | |||
| about a foot (50 cm) away. |
8