Position an XLVC grid underneath the XLVC loudspeaker system, as shown in Figure 10a. Insert the loose swing arms on the bottom of the enclosure into the rear rigging channels on the grid and attach the arms to the grid in the top hole with the quick-release pins. Swing the grid up and insert the exposed hinge bars at the bottom front of the enclosure into the front rigging tubes on the grid and secure using the quick-release pins. The standard grid is now attached to the bottom of the enclosure.

ALWAYS MAKE SURE THAT THE LEFT AND RIGHT SWING ARMS ON THE ENCLOSURE ARE LOCKED INTO THE SAME HOLES FOR THE SAME VERTICAL SPLAY ANGLE ON THE GRID.

ALWAYS MAKE SURE THAT THE QUICK-RELEASE PINS FOR EVERY SWING ARM PASS THEROUGH THE HOLE IN THE SWING ARM AND ARE FULLY LOCKED IN THE RIGGING CHANNELS IN THE GRID.

A 5/8-inch shackle can be installed into the center position of the spreader bar on the bottom grid. A ratchet strap can be attached to the shackle to enable adjustment for pull up. The entire array can then be lifted, as shown in Figure 10b, and the vertical tilt angle adjusted as necessary using the ratchet strap.

The XLVC-BGK may also be used with the AGCD adapter grid for groundstacking XLD281 loudspeaker systems on top of XLC loudspeaker systems. See the AGCD section for details.

XLD281, XLE181, or

XS212 Loudspeaker at

Bottom of Array

Quick-Release Pins

Rear Positions

(4 Included in Kit)

Shoulder Bolt for

Locking Hinge Bar into Bottom

Loudspeaker

(2 Included in Kit)

Screw for Attaching

Lanyards to Loudspeaker (2 Included in Kit)

Quick-Release Pins

Front Positions

(4 Included in Kit)

Rear Swing Arms

(2 Included in Kit)

Note: Correct Assembly

of Left and Right Hinge

Bars can be Verified by

Alignment of Holes at

the Rear of Rigging Tube

on Bottom Loudspeaker

Front Hinge Bars

Note: Assembly of

(2 Included in Kit)

All Pins and Screws

XLD or XLE Grid

 

Apply to both Left

 

Installed Upside Down

 

and Right Sides

 

Figure 10a: (Grid Sold Separately)

 

 

Figure 10b:

Assembling the XLVC-BGK and

XLVC Array with XLVC-BGK and

Secondary Grid at the Bottom of an Array

Secondary Grid as a Pull-Up

31

ELECTRO-VOICE®X-Line Very CompactTM Rigging Manual

Page 32
Image 32
Electro-Voice X-Line Very Compact (XLVC) manual Assembling the XLVC-BGK