Installation
Set the machine
upright and remove the two remaining bolts
from the back.
Pull out the three
plastic spacers from 
the holes into
which the bolts were fitted.
Plug the open holes with the plugs which you will find at the back of the machine.
You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is not impeded by carpets, rugs etc.
•Before placing it on small tiles, apply a rubber coating.
•Never try to correct any unevenness in the floor by putting pieces of wood, cardboard or similar materials under the machine.
•If it is impossible to avoid positioning the machine next to a gas cooker or
•The machine must not be installed in rooms where the temperature can drop below 0.
•The water inlet hose and the drain hose must not be kinked.
•Please ensure that when the appliance is installed, it is easily accessi- ble for the engineer in the event of a breakdown.
Levelling
Carefully level by screwing the
adjustable feet in or out. Never place cardboard, wood or similar
materials under the machine to compensate for
any unevenness in the floor.
After having levelled the machine, tighten the lock nuts.
46
