Changing The Filter 29
More about your advanced water filter
The PureAdvantageTM ice and water filter system is tested and certified by NSF International, the nationally
respected,
The PureAdvantageTM ice and water filter system is tested and certified to ANSI/NSF Standards 42 and 53 for the reduction of claims specified on the performance data sheet.
Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.
Test & certification results:
•Rated Capacity - 400 gallons for
PureAdvantageTM ice and water filter
•Rated service flow
•Maximum Rated Pressure - 100 pounds per square inch
•Operating Temp.: Min. 33° F, Max. 100° F
•Recommended Minimum Operating
Pressure: 30 pounds per square inch
To replace your PureAdvantageTM water filter:
It is not necessary to turn the water supply off to change the filter. Be ready to wipe up any small amounts of water released during the filter replacement.
1Turn Off the ice maker power switch.
2Push the filter release button below the cartridge to disconnect it.
3Slide the old water filter cartridge straight out of the housing and discard it.
4Unpackage the new filter cartridge and slide it gently into the filter housing until it stops against the
5Push firmly until the cartridge snaps into place (you should hear a click as the cartridge engages the
6Press a drinking glass against the water dispenser while checking for any leaks at the filter housing. Any spurts and sputters that occur as the system purges air out of the dispenser system are normal.
7After filling one glass of water, continue flushing the system for about three minutes.
8Turn On the ice maker.
9Press and hold the Filter Status button on the Ice & Water Dispenser control panel for three seconds. When the display changes from “Replace” to “Good,” the status has been reset.
