Electrolux 269550, 267554, 267552, 267553, 267550, 269552 Installation of Accessories, Always install

			USA
3.2 WARNINGS REGARDING THE FLUING SYSTEM		CONSTRUCTION TYPE	1b
Before installation check, on the basis of the contents of the
		B13
reference standard, to ensure that the volume aspirated by the
fumes exhausting system is greater than the volume of combusted
gas produced by the appliance (see point 1.1).
If the solution of combusted gas discharge under an extractor
hood is chosen, observe the distance (shown in the figure)
between the top of the discharge pipe and the lowest point of the
hood filters. This distance is defined on the basis of discharge
pipe diameter "D".
In the case of discharge direction to the outside or into a central
flue (Fig. "1c"), the discharge ducts must NOT present an overall
length in excess of 762"(3 metres), must NOT have any reductions
in diameter, and must be subjected to periodic inspection and,
when necessary, cleaning.
Warning: Since combusted gas (see figure) can reach very
high temperatures, check the heat resistant properties of
extension ducts if fitted and the filters in the extractor hood
to ensure the materials are compatible with the temperature
conditions. In addition, periodically check the condition of
the filters which, if excessively fouled with fat and dirt, will
reduce the efficiency of the suction system and may catch
fire.
3.3 INSTALLATION OF ACCESSORIES
Accessories can be easily installed by following the figures below
together with the relative key.
The screw holes for fixing accessories "A" and "F" are 0.14"(3.5
mm) in diameter and they must be drilled in-situ on the oven cover		DISCHARGE WITH SHROUD UNDER EXTRACTOR HOOD
in correspondence with the punch marks.
CONSTRUCTION TYPE	1a	CONSTRUCTION TYPE	1c
A3		B13
DIRECT UNDUCTED DISCHARGE UNDER EXTRACTOR HOOD		DISCHARGE TO THE OUTSIDE OR CENTRAL FLUE WITH SHROUD

	LEGENDA:		F:		Conical connections for single outlet (supplied)
	A:	Cam / draught damper accessory
		(to be ordered from manufacturer)	G:		(always install)
	B:	Boiler combusted gas discharge			Fixing screws (supplied);
01	C:	Oven chamber convector combusted gas discharge	*:		Commercial extension pipes (not supplied)
	E:	Adapter ring for commercial ducts				:
036				SILICONE
		(to be ordered from manufacturer)			Apply silicone sealant between contact surfaces
5938

15