Electrolux 318201475 (0710) Check Operation, Burner Bases and Burner Caps

GAS COOKTOP INSTALLATION INSTRUCTIONS

Check Operation

Refer to the Use and Care Guide packaged with the cooktop for operating instructions and for care and cleaning of your cooktop.

Do not touch the burners. They may be hot enough to cause burns.

1. Burner Bases and Burner Caps

This range is equipped with sealed burners as shown (Figure 8). All pieces are at their place. Take note where they are. Remove all packaging material located under the Dual Surface burner head. Make sure the burner is properly aligned and leveled.

NOTE: There are no burner adjustments necessary on this range.

4. Adjust the "LOW" Setting of Regular Burner (see

figure 8) on the Surface Burner Valves (Figure 9):

a. Push in and turn control to LITE until burner ignites.

b. Quickly turn knob to LOWEST POSITION.

c. If burner goes out, reset control to OFF.

d. Remove the surface burner control knob and

decorative ring.

e. Insert a thin-bladed screwdriver into the hollow valve

stem and engage the slotted screw inside. Flame size

can be increased or decreased by turning the screw.

Turn counterclockwise to increase flame size. Turn

clockwise to decrease flame size. Adjust flame until

you can quickly turn knob from LITE to LOWEST

POSITION without extinguishing the flame. Flame

should be as small as possible without going out.

Note: Air mixture adjustment is not required on surface

30” Model

Burner Cap

Burner Base

36” model

Fixed Burner Ring

Burner Cap

Fixed Burner Ring and Burner Base

burners.

Dual Surface	Regular Burner
Burner

Figure 8

2.Turn on Electrical Power and Open Main Shutoff Gas Valve

3.Check the Igniters

Operation of electric igniters should be checked after range and supply line connectors have been carefully checked for leaks and range has been connected to electric power. To check for proper lighting: a.Push in and turn a surface burner knob to the LITE

position. All electronic surface ignitors will spark at the same time. However, only the burner you are turning on will ignite.

b.The surface burner should light once the flow of gas reached the surface burner. Each burner should light within four (4) seconds in normal operation after air has been purged from supply lines. Visually check that burner has lit.

c. Once the burner lights, the control knob should be rotated out of the LITE position.

There are separate ignition devices for each burner. Try each knob separately until all burner valves have been checked.

Figure 9

7