Installation and Connection Instructions
•If the dishwasher is installed under- neath a kitchen work surface, the original work surface of the dish- washer is to be removed as follows:
–Unscrew the screws (1) from the elbows on the back side.
–Slide the work surface approx. 1cm to the rear (2) , lift at the front (3) and remove.
–Press the work surface retaining brackets at the position shown in the diagram (4) and remove the bracket at an angle to the rear
(5).
4 |
5 |
1 | If the dishwasher is later used as a |
| work surface must be |
3 The plinth on free-standing appliances is not adjustable.
•
match the facings of other kitchen equipment. The décor panels must be obtained from the kitchen man- ufacturer. A décor frame is neces- sary for installation, and can be obtained as an accessory from the dealer if not included in the scope of delivery.
• Decor panel dimensions:
– Height 590 mm
–Width 581 mm
–Clamp thickness: max. 4 mm
•To ensure that thin decor panels do not flex or distort, attach them to the door of the appliance using double sided adhesive tape.
30
