Connection
IMPORTANT: This hob must be installed by a competent person to the relevant Gas Standards.
Any gas installation must be carried out by a competent person.
The manufacturer will not accept liability, should the above instructions or any of the other safety instructions incorporated in this book be ignored.
Carry out connection to the gas supply using a rigid metal pipe with connections conforming to the rules in force, or with a flexible s/steel tube conforming to the relevant rules in force, limited to those whose max. length is 2 m. If flexible metal tubes are used, make sure they do not come into contact with mobile parts or are crushed. Pay the same attention also when an oven and top combination is provided for. The appliance gas inlet connection is 1/2" cylindrical threaded male. Screw the parts together without using excessive force.
IMPORTANT: After installation, always check the perfect tightness of all the connections, using a soapy solution. NEVER carry out this check with a flame.
A) Gas ramp end with nut B) Washer
C) Elbow
28
