How to Wire Your Ceiling Fan (continued)
| STANDARD |
|
|
| SWITCH OR OPTIONAL SW406 |
| |
| WALL CONTROL | BLACK |
|
TO | BLACK |
| |
|
| ||
(HOT) |
| BLACK | |
120- |
|
|
|
VOLT |
|
| WHITE |
SUPPLY | WHITE |
|
|
| WHITE |
| |
|
|
|
GROUND | RED |
|
BLUE | WHITE | |
CABLE (WITH |
|
|
GROUND) |
|
|
GREEN WIRE (GROUND) | BLACK |
|
BLUE |
| |
FROM HANGER BALL AND | WHITE |
|
HANGER BRACKET |
|
|
| HANGER BALL |
Figure 15
! WARNING
To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.
3. | Push the wires and connectors up into the outlet |
| box while inserting the receiver fully into the hang- |
| er bracket. Position the antenna wire on top of the |
| receiver. |
4. | Screw the two |
| into the tapped holes in the hanger bracket (Figure |
| 16). |
5. | Lift the ceiling cover up to the threaded studs and |
| turn until the studs protrude through the holes in |
| the ceiling cover (Figure 16). |
6. | Secure the ceiling cover in place by sliding lock- |
| washers (supplied) over the threaded studs and |
| installing the two knurled knobs (supplied). (Figure |
| LOCKWASHER |
| (2) |
Figure 16 | KNURLED |
KNOB (2) |
CEILING
COVER
THREADED STUD (2)
16). Tighten the knurled knobs securely until the |
ceiling cover fits snugly against the ceiling. |
7. Screw the two |
gen bulbs (supplied) into the light kit plate sockets |
(Figure 17). Do not touch the glass bulb; use the |
porcelain base to screw in the bulb, or wear soft |
gloves. |
CAUTION: To avoid risks of burns or other injury, assure power is off before attempting to install or replace the halogen bulbs.
NOTICE: Do not touch halogen bulbs with bare hands. Fingerprints may result in shorter bulb life. Remove fingerprints with alcohol.
|
| LIGHT KIT |
|
| PLATE |
|
| |
| HALOGEN | FLAT AREA |
| BULB (2) | |
|
| |
Figure 17 |
| GLASS |
8.Place the lower glass into the light fitter, aligning the three flat areas on the top flange of the lower glass with the three pins on the inside of the fitter (Figure 17). Then turn the lower glass clockwise until it stops turning.
9.Your ceiling fan is now installed and wired to be controlled by your wall control.
10 | U.L. Model No.: CF205 |