How to Assembly Your Ceiling Fan (continued)
13.Slide the rod support assembly up the downrod until the threaded holes in the rod support align with the holes in the decorative rod assemblies (Figure 9). Secure the decorative rods to the rod support using three decorative rod screws; do not tighten the rod screws at this time.
14.Rotate the rod support assembly until the decora- tive rod assemblies are aligned vertically with the downrod (Figure 9). Hold the rod support in this position while tightening all six decorative rod screws securely.
!
WARNING
It is critical that the pin in the hanger ball is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are proper- ly installed could result in the fan falling.
15.Place the ceiling cover over the downrod. Then reinstall the hanger ball (Figure 10) on the down- rod as follows. Route the three 80” motor leads through the hanger ball and slide the hanger ball over the downrod. Position the pin through the two holes in the downrod and align the hanger ball so the pin is captured in the groove in the top of the hanger ball. Pull the hanger ball up tight against the pin and securely tighten the setscrew in the hanger ball. A loose setscrew could create fan wobble.
16.The fan comes with blue, black and white leads that are 80” long. Before installing the fan, mea- sure up approximately 6 to
17.You have now completed the initial assembly of your new ceiling fan. You can now proceed with hanging and wiring your fan.
ROD
DOWNRODSUPPORT 
ASSEMBLY
DECORATIVE
ROD SCREW
DECORATIVE
ROD
ASSEMBLY
Figure 9
PIN
HANGERBALL
DOWNROD
SETSCREW
CEILING
COVER
Figure 10
7 | U.L. Model No.: CF205 |
