Unpacking Instructions, Tools Needed for Assembly

This Manual Is Designed to Make it as Easy as Possible for You to Assemble,

Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver	One stepladder
One wire cutter	One wire stripper

MATERIALS

Wiring outlet box and box connectors must be of type required by the local code. The minimum wire would be a 3-conductor (2-wire with ground) of the following size:

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50-100 ft.	12

! WARNING

Before assembly your ceiling fan, refer to section on proper method of wiring your fan (page 6). If you feel you do not have enough wiring knowl- edge or experience, have your fan installed by a licensed electrician.

Unpacking Instructions

! WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

! WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or acces- sories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage.

1.Open styrofoam unit containing fan. Remove top half of styrofoam unit. Remove parts and check to see that you have received the following parts:

NOTE: If you are uncertain of part description, refer to exploded view illustration.

a.Fan motor/housing assembly

b.One ceiling cover

c.One coupling cover

d.Three fan blades

e.Three blade flanges

f.Nine decorative blade nuts (bagged)

g.One hanger bracket

h.One hanger ball/12” downrod assembly

i.One 6” downrod

j.One rod support assembly

k.Three decorative rod assemblies

l.Six decorative rod assembly screws (bagged)

m.One light kit plate

n.One lower glass

o.One cover plate

p.Two 50-watt mini-candelabra base halogen bulbs

q.One remote control transmitter

r.One remote control receiver

s.One loose parts bag, containing:

1.Two 1-1/4” threaded studs

2.Two knurled knobs

3.Two lockwashers

4.Seven wire connectors

5.One hairpin clip

6.One clevis pin

7.Seven 1/4-20 x 11mm pan head screws (bagged)

8.Ten 10-24 x 9mm oval head screws (bagged)

NOTE: Place the parts from the loose parts bags in a small container to keep them from being lost. If any parts are missing, contact your local retailer or catalog outlet for replacement before proceeding.

2.Remove the fan motor/housing assembly from the protective plastic bag. Place the fan assembly into the lower foam pad with the bottom of the motor facing up.

The lower foam pad serves as a holder for the fan during the first stages of assembly.