How to Assembly Your Ceiling Fan (continued)
Your ceiling fan can be assembled with the light kit and glass or without the light kit and glass. To assemble without the light kit and glass, you will use the
NOTE: In order to remove the light sockets, the wires on the light kit plate will need to be cut.
MAKE SURE THIS IS THE NO LIGHT ASSEMBLY DESIRED.
NOTE: If no light kit is to be used on the ceiling fan, disregard Steps 4 and 5; proceed to “How to Disassemble Your Light Kit for Cover Plate Assembly Only”, then continue to Step 6.
4.Connect the white wire from the light kit plate to the white wire in the fan motor/ housing assembly (Figure 3). Connect the black wire from the light kit plate to the black wire in the fan motor/housing assembly.
CAUTION: Before installing and tightening the screws, be sure there are no wires pinched between the light kit plate and the fan motor/housing assembly.
5.Remove one of the fan motor/housing assembly screw (retain for later use). Position the light kit plate on the fan motor/housing assembly aligning the keyhole slots over the fan motor screws. Rotate the light kit plate clockwise to engage the screws into the keyhole slots. Reinstall the previous removed screw. Tighten the three screws to secure the light kit plate to the fan motor/housing (Figure 4).
6.Carefully remove the fan assembly from the lower foam pad. Turn the fan assembly over and posi- tion it on the lower foam pad with the light kit plate resting on the pad so that the top of the motor faces up.
7.Remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 5). Remove the pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstallation in Step 15.
NOTE: If you have an
8.Unscrew the two upper setscrews (Figure 5) until they clear the inside of the motor coupling. Then separate, untwist and unkink the three 80” motor leads. Route the motor lead wires through the downrod. Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the cle- vis pin and secure with the hairpin clip (Figure 9).
LIGHT KIT
PLATE
BLACK WIRE
BLUE WIRE
FAN MOTOR/
HOUSING
ASSEMBLY
WHITE WIRES
Figure 3
MOTOR | LIGHT KIT |
SCREW (3) | |
| PLATE |
Figure 4
PIN
HANGER
BALL
DOWNROD
SETSCREW
Figure 5
The clevis pin must go through the holes in the motor coupling and the holes in the downrod. Be sure to push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose. Pull up on the downrod to make sure the clevis pin is properly installed.
5 | U.L. Model No.: CF205 |