How to Assembly Your Ceiling Fan
!
WARNING
It is critical that the clevis pin in the motor coupling is properly installed and the setscrews securely tightened. Failure to verify that the pin and setscrews are properly installed (as shown in Figure 6) could result in the fan falling.
9.Tighten the setscrews (Figure 6) securely while pulling up on the downrod.
NOTE: The setscrews must be properly installed as described above, or fan wobble could result.
10.Make sure the grommet Is properly installed in the coupling cover, then slide the coupling cover over the downrod until it rests on the motor housing. (Figure 7).
NOTE: If you installed the 6” downrod, the three decorative rod assemblies and the rod support assembly will not be installed. Disregard Steps 12 through 14; proceed to Step 15.
HAIRPIN
CLIP
DOWNROD
MOTOR COUPLING
SETSCREW (2)
REVERSE
SWITCH
CLEVIS PIN
Figure 6
ROD SUPPORT | GROMMET |
ASSEMBLY |
|
SCREWS (3) (Toward Top)
11.Make sure the grommets are properly installed in the rod support assembly. Then position the three screws in the rod support toward the top, and slide the rod support over the downrod (Figure 7).
12.Using the decorative rod screws (supplied), attach the three decorative rod assemblies to the motor housing (Figure 8). The decorative rods must be oriented so that they lean in towards the downrod. Do not tighten the rod screws at this time.
MOTOR
HOUSING
Figure 7
COUPLING COVER
DECORATIVE ROD
ASSEMBLY
DECORATIVE
ROD SCREW
Figure 8
6 | U.L. Model No.: CF205 |
|
