Remote Control Procedures (continued)
Setting Operating Frequency of
Transmitter
Your remote control transmitter has code switches which must be set in one of 32 possible code combi- nations. The five levers (numbered 1, 2, 3, 4, and 5) on the switches are
1.Slide the five switch levers in the remote control (transmitter) to your choice of ON (up) or down positions. Use a
2.When power is restored after installation of the wall
control, push and hold the fan OFF button ( ) for 3 to 5 seconds to set the code in the receiver.
3.The sixth switch marked ON and I is for dimming control of lights: Set switch to ON to allow for dim- ming of the lights. Set switch to I for no dimming of the lights such as for fluorescent bulbs.
4.Install the batteries in the transmitter battery com- partment and replace the battery cover.
Installation of Storage Bracket
COVER
WALL
BRACKET
SCREW
HOLES (2)
POWER
INDICATOR
LIGHT
FAN
BUTTON
LIGHT
BUTTON
Figure 23
TO INSTALL BRACKET TO WALL:
SLIDE THE COVER UP TO EXPOSE THE SCREW HOLES FOR INSTALLATION
HIGH TO LOW
BUTTONS
STORAGE
BRACKET
A storage bracket is provided for holding your remote control when not in use (Figure 23). If you desire to use the bracket, install it on a wall that is away from excess heat or humidity.
Operation of Remote Control
IMPORTANT
Fan installation must be completed, including the installation of the fan blades, before testing of the remote control.
Your remote control has full control of your fan and light (Figure 23).
NOTE: Prior to operation of the fan and light from the remote control, set the fan speed to HIGH (....)
and turn the light ON ( ).
1.To set the desired fan speed, hold the FAN ( ) button down, then press one of the four buttons (., .., ..., ....) to operate your fan from low to high speeds.
2.To turn the light on and off, press the LIGHT ( ) button down, then press one of the four buttons (., .., ..., ....) to operate your light intensity from low to high intensities.
Note: When turning the light on, light will turn on at the light intensity previously selected.
3.If airflow is desired in the opposite direction, turn the fan off and wait for the blades to stop turning. Then slide the coupling cover up, push the revers- ing switch in opposite direction (Figure 24) Slide coupling cover down to rest on motor housing and turn the fan on again. The blades will turn in the opposite direction and reverse the airflow.
COUPLING
COVER
MOTOR
HOUSING
REVERSE |
SWITCH |
Figure 24
13 | U.L. Model No.: CF205 |