Installation 17
MOUNTING THE HOOD TO SUPPORT FRAME
1 Insert four (4) bolts through the top of the hood from the inside.
2Use four (4) nuts and four (4) washers to secure hood to support frame.
INSTALLING THE ELECTRICAL
WASHER NUT
BOLT
Figure 12
WARNING
Electrical wiring must be done by a qualified person(s) in accordance with all applicable codes and standards. This range hood must be properly grounded. Turn off electrical power at service entrance before wiring.
1Remove the wiring box cover. Remove a knockout from the wiring box.
2Feed 6” of power cable through the knockout opening and secure cable to the wiring box with an appropriate connector.
3Make electrical connections. Connect white to white, black to black and green to green.
4Replace wiring box cover and screws. Check that wires are not pinched between cover and box.
WIRING BOX COVER
Figure 13
