Connecting the Ductwork

LOWER

FLUE

RETAINING

SCREWS

MOUNTING SCREWWS (3.9 x 9.5 mm)

Figure 15

1Use 8” round metal duct to connect the discharge collar on the hood to the ductwork above.

2Use duct tape to make all joints secure and air tight.

3Remove the two temporary retaining screws from the lower ﬂue and set it in place on the hood.

4Secure decorative ﬂue to hood with two mounting screws (3.9 x 9.5mm). pan head mounting screws.

REPLACING THE BOTTOM TRIM

1Remove the four (4) screws from the inside of the hood.

2 Remove the trim by pulling downward.

3 Slide the new trim upward into hood.

4 Replace the four screws inside hood.

Figure 16

Image 18

Contents

Use & Care Guide Installation Instructions QUESTIONS? Finding InformationRead and Save These Instructions 877- 4ELECTROLUX Table of Contents Safety Important Safety Instructions Safety Precautions Safety Safety Getting Started Operating Your HoodAuto-Start Heat Sensing System Operation Halogen BulbsBulb may be hot Fuse Replacement Use of a fuse greater than 4 amps may damage the transformer Hood Cleaning Care and CleaningCleaning the Filters and Hood Grease Filters Installation Installation Planning Verify Package Contents Installing the Ductwork To reduce the risk of ﬁre, use only metal ductwork Installation15 Installing the Support SystemRequires optional 10-foot ﬂue extension model EXPV100S Connecting the Decorative Flue Installing the Duct Collar Installing the Electrical Mounting the Hood to Support Frame Connecting the Ductwork Replacing the Bottom Trim Installing the Filters Prior to use, remove protective ﬁlm from the ﬁlter frame Troubleshooting If Service is Required Troubleshooting Guide Problem Possible Cause Remedy Saving Energy Energy Saving TipsPage Warranty Hood Warranty Your hood is protected by this warranty