Electrolux EDI97170W user manual Technical data, Changing the bulb for interior lighting

22electrolux

Programme inactive, CONTAINER display illu- minated.

Drying cycle ends shortly after programme starts.

ANTICREASE display illuminated.

Drying cycle lasts an un- usually long time. Note: After up to 5 hours the drying cycle ends auto- matically (see ‘End of dry- ing cycle’).

Condensed water container is full.

Not enough washing loaded or washing loaded is too dry for selec- ted programme.

Lint filter clogged.

Fluff filter clogged.

Empty Condensed water contain- er , then start programme with START/PAUSE button.

Select time programme or higher drying level (e.g. EXTRA instead of CUPBOARD).

Clean lint filter.

Clean fluff filter.

Load volume too big.

Laundry insufficiently spun.

Particularly high room temperature. Temporary switching off of the compressor to avoid overload.

Discoloration Colour fastness of textiles.

Reduce load volume.

Laundry must be adequately spun.

Automatic process, there is no fault with the appliance. If possible, low- er the room temperature.

Check colour fastness of textiles. Only treat textiles together if they are a similar colour.

Changing the bulb for interior lighting

Only use a special bulb which is designed specially for dryers. The special bulb can be obtained from your local Service Force cen- tre.

Warning! When the appliance is switched on, the interior lighting switches itself off after 4 minutes when the door is open.

Warning! Do not use standard bulbs! These develop too much heat and may damage the machine!

Warning! Before replacing the bulb, disconnect the mains plug.

1.Unscrew cover above the bulb (this can be found directly behind the loading aper- ture, at the top; refer to “Description of machine” section.)

2.Replace defective bulb.

3.Screw cover back down.

Check the correct positioning of o-ring gas- ket before screwing back the door light cov- er. Do not operate the dryer when missing o- ring gasket on door light cover.

Warning! For safety reasons, the cover must be screwed down tightly. If this is not done, the dryer must not be operated.

Technical data

This appliance conforms with the following EU Directives:

–2006/95/EC dated 12.12.2006 Low Voltage Directive

–89/336/EEC dated 03.05.1989 EMC Directive inclusive of Amending Directive 92/31/EEC

–93/68/EEC dated 22.07.1993 CE Marking Directive

Height x width x depth

Drum volume

Depth with loading door open

Height can be adjusted by

85 x 60 x 58 cm

108l

109cm 1.5 cm