Electrolux EDI97170W user manual After a IronAid pro

After a IronAid pro-	Wrong programme selected (e.g.
gramme, garments are	SYNTHETICS instead of
not sufficiently smooth.	COTTON).

Too low a LOAD level set.

electrolux 21

Note the composition of the fabric.

Set a higher LOAD level.

After a IronAid pro- gramme, there are no creases left in the gar- ments.

Drying results unsatisfac- tory.

Too many garments in machine, or garments that are too different.

Clothes are not removed until the anti-crease phase is finished.

Garments not hung on clothes hangers and/or not tugged into shape.

Multi-layered garments tend to lose their shape.

The IronAid programme has the ef- fect of smoothing garments.

Wrong programme selected.

Lint filters clogged.

Load the machine with fewer gar- ments, or only similar ones.

Remove clothes quickly one at a time from the machine as soon as possible after the start of the anti- crease phase.

Hang garments on clothes hang- ers, do up buttons and tug gar- ments into shape.

Reshape multi-layered garments by ironing after they come out of the machine.

Iron creases in again after the Iron- Aid programme.

Select a different programme the next time you dry (see “Programme overview” chapter).

Clean lint filters.

Fluff filter clogged.

Heat exchanger clogged with lint.

Clean fluff filter.

Clean heat exchanger.

When a button is pressed - no reaction of the ma- chine.

Drum light does not work.

Displayed programme time changes erratically or stays unchanged for a long time.

Overloading of laundry.

Ventilation slots in base area cov- ered up.

Residue on inside surface of drum or drum ribs.

Conductance of water at installa- tion site differs from standard set- ting of machine.

Drying protection. After the start of the programme, the option can no longer be set.

Programme selector in OFF posi- tion.

Defective light bulb.

Programme time is corrected auto- matically depending on type and volume of laundry and level of dampness.

Observe recommended loading volumes.

Uncover ventilation slots in base area.

Clean inside surface of drum and drum ribs.

Make an adjustment using the DRYNESS function (see chap- ter ”Drying”)

Re-programme standard setting for degree of drying (see ‘Program- ming options’ chapter).

Turn the programme knob to OFF. Set the programme again.

Turn programme selector to any programme.

Replace light bulb (see next sec- tion).

Automatic process; this is not a machine fault.