20 electrolux

Installation Instructions

1 Safety instructions

• CAUTION: The surface temperature ex-

Warning! This must be read!

ceeds 95°C. To avoid a hazard, under-

bench access must be restricted.

The laws, ordinances, directives and stand-

• Supply cords must have a temperature

ards in force in the country of use are to be

rating not less than 105°C.

followed (safety regulations, proper recycling

Electrical Connection

in accordance with the regulations, etc.)

Installation may only be carried out by a qual-

Before connecting, check that the nominal

ified electrician.

voltage of the appliance, that is the voltage

The minimum distances to other appliances

stated on the rating plate, corresponds to

and units are to be observed.

the available supply voltage. Also check the

Anti-shock protection must be provided by

power rating of the appliance and ensure

the installation, for example drawers may

that the wire is suitably sized in accordance

only be installed with a protective floor direct-

with local wiring rules. The rating plate is lo-

ly underneath the appliance.

cated on the lower casing of the hob.

The cut surfaces of the worktop are to be

The heating element voltage is AC230V~.

protected against moisture using a suitable

The appliance also works perfectly on net-

sealant.

works with AC220V~ or AC240V~. Means

The sealant seals the appliance to the work

for disconnection must be incorporated in

top with no gap.

the fixed wiring in accordance with local wir-

When building in, protect the underside of

ing rules.

the appliance from steam and moisture, e.g.

The hob is to be connected to the mains us-

from a dishwasher or oven.

ing a device that allows the appliance to be

Avoid installing the appliance next to doors

disconnected from the mains at all poles with

and under windows. Otherwise hot cook-

a contact opening width of at least 3 mm,

ware may be knocked off the rings when

eg. automatic line protecting cut-out,earth

doors and windows are opened.

leakage tripsorfuse.

z Risk of injury from electrical cur-

If this appliance’s mains cable is damaged, it

rent.

must be replaced by a special cable (type

• The electrical mains terminal is live.

H05BB-F Tmax 90°C; or higher). The latter is

• Make electrical mains terminal free of

available from the Customer Care Depart-

voltage.

ment.

• Follow connection schematic.

The connection must be carried out as

• Observe electrical safety rules.

shown in the diagram, refer to the sticker on

• Ensure anti-shock protection by install-

the back of the hob for wiring connection di-

ing correctly.

agram. The connecting links should be fitted

• The appliance must be connected to the

according to the appropriate connection di-

agram. Note for single phase connection,

electrical supply by a qualified electri-

the link (or bridge) will need to be fitted be-

cian.

tween terminals 1 & 2 (refer to the connec-

z Risk of injury from electrical cur-

tion sticker on back of the unit). The earth

rent.

lead is connected to terminal E. The earth

• Loose and inappropriate plug and sock-

lead must be longer than leads carrying elec-

et connections can make the terminal

tric current.

overheat.

The cable connections must be made in

• Have the clamping connections correct-

accordance with regulations and the

ly installed by a qualified electrician.

terminal screws tightened securely.

• Use strain relief clamp on cable.

 

Page 20
Image 20
Electrolux EHD 60150 IAU user manual Installation Instructions, Electrical Connection