components as shown in the diagram. Screw the parts together without using ex- cessive force.
1
2
3
1End of shaft with nut
2Washer
3Elbow
Connection to the gas supply should be with either rigid or
The connection should be suitable for con- necting to R 1/2 (1/2 BSP male thread). When the final connection has been made, it is essential that a thorough leak test is carried out on the hob and installation. Make sure that the main connection pipe does not exert any strain on the hob.
If you use flexible metal pipes make sure that they agree to ISO 10380 and ISO 10807 standards. Be careful they do not come in touch with mobile parts or they are not squeezed. Also be careful when the hob is put together with an oven.
Important! It is important to install the elbow correctly, with the shoulder on the end of the thread, fitted to the hob connecting pipe.
Important! Failure to ensure the correct assembly will cause leakage of gas.
Important! Make sure that the gas supply pressure of the appliance obeys the recommended values.
Rigid connection:
Carry out connection by using metal rigid pipes (copper with mechanical end).
Injectors replacement
1. Remove the pan supports.
electrolux 5
2.Remove the caps and crowns of the burner.
3.With a socket spanner 7 remove the in- jectors and replace them with the ones which are necessary for the type of gas you use (see table in Technical Data section).
4.Assemble the parts, follow the same procedure backwards.
5.Replace the rating label (it is near the gas supply pipe) with the one for the new type of gas supply. You can find this label in the package of the injectors
supplied with the appliance.
If the supply gas pressure is changeable or different from the necessary pressure, you must fit an applicable pressure adjuster on the gas supply pipe.
Adjustment of minimum level
To adjust the minimum level of the burners:
1.Light the burner.
2.Turn the knob on the minimum position.
3.Remove the control knob.
4.With a thin screwdriver, adjust the by- pass screw position. If you change from natural gas 20 mbar to liquid gas, fully tighten the adjustment screw in. If you change from liquid gas to natural gas 20 mbar, undo the
1
1Minimum adjustment screw
5.Make sure the flame does not go out when you quickly turn the knob from the maximum position to the minimum posi- tion.
Electrical connection
•Any electrical work required to install this hob should be carried out by a qualified electrician or competent person, in ac- cordance with the current regulations.
•THIS HOB MUST BE EARTHED.
